Mounting The Unit - Korenix JetCon 2502 Guía De Instalación Rápida

Introduction
JetCon 2502 is an Ethernet/POTS to VDSL2 (Very High-Rate Digital Subscribe Loop -2)
extender and is compliance with ITU-T G.993.2 standard. It allows VDSL2 carriers to
deliver Ethernet data up to 100Mbps in both upstream and downstream over existing
twisted copper plant.
For the network infrastructural, this product is the best choice for planning centralized
internet access through the existing POTS wiring system for hotels, dormitories or where
need extend LAN over 100m through a single pair copper.
The converter allow users to compete with wireless and satellite providers by offering
outstanding service, such as Video conference, HDTV or Video chatting over a existing
telephone copper cable without any configuration, just plug and play.
This document will direct how to install the Ethernet over VDSL extender-JetCon 2502.
Package contents Check List
JetCon 2502
Quick Installation Guide (QIG)
DIN rail mount kit with screws

Mounting the Unit

Din-Rail mount: screwed up the DIN-rail
clip on the rear of JetCon 2502 and mount
on the EN50022 type rail.
More information about the DIN Rail installation,
please refer the user's manual- chapter 3.
Wiring the Power Inputs
1. Insert the positive and negative wires into the V+ and V- contact on the top side of
terminal block connector.
2. Connects the earth ground wiring to the middle conductor of top side terminal block.
JetCon 2502
Ethernet over VDSL extender
Quick Installation Guide
v 1.0 www.korenix.com
V1.0
V1.0