Water Filter - KENMORE ELITE 795.5182 Serie Manual De Uso

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

WATER FILTER

It is recommended that you replace the water fi lter:
• Approximately every 6 months.
• When the water fi lter indicator turns on.
• When the water dispenser output decreases.
• When the ice cubes are smaller than normal.
1. Remove the old water filter.
Press the push button to open the
water fi lter cover.
NOTE: Replacing the water fi lter
causes a small amount of water
(around 1 oz. or 25 cc) to drain. Place
a cup under the front end of the water fi lter cover to
collect any leaking water. Hold the water fi lter upright,
once it is removed, to prevent any remaining water from
spilling out of the water fi lter.
Pull the water
fi lter downward
and pull out.
Make sure to
rotate the fi lter
down completely
before pulling
it out of the
manifold hole.
2. Replace with a new water fi lter.
Take the new water fi lter out of its packing and remove
the protective
cover from the
o-rings. With the
water fi lter tabs
in the horizontal
position, push the
new water fi lter
into the manifold
hole until it stops.
WATER FILTER
Rotate the water
fi lter up into
position and
close the cover.
The cover will
click when closed
correctly.
3. After the water fi lter is replaced, dispense 2.5
gallons of water (fl ush for approximately 5 minutes)
to remove trapped air and contaminants from
the system. Do not dispense the entire 2.5 gallon
amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
NOTE: To purchase a replacement water fi lter, visit a
Sears store or call 1-800-4-MY-HOME
order on-line at www.sears.com/partsdirect
23
. You may also
®

Capítulos

Tabla de contenido
loading

Tabla de contenido