FITTING INSTRUCTIONS
Please take a few moments to read through these instructions.
They cover fitting, usage and answer many questions.
NOTE: It is best to carry out your JAS therapy session in a comfortably seated position.
If swelling is present, placing your foot in an elevated position is suggested. You should
not be up walking during a JAS treatment session.
STEP 1:
INITIAL DORSI-FLEXION / PLANTAR-FLEXION TOE PLATE
ATTACHMENT
Plantar Flexion Position
Dorsi Flexion Position
STEP 2:
SECURE FOOT IN DEVICE
TOE DEVICE
• Loosen and remove
white knob at base of
toe plate sliding mechanism.
• Slide toe plate mechanism off
of its attachment, flip and
re-attach.
Remove knob and flip toe plate
• Place foot on foot
plate, making sure joint
of the first toe is
aligned with fulcrum of
device (center circle
on metal upright), and
first toe clears foot plate.
Fulcrum
• Secure gray
strap behind heel,
comfortably snug.
Step 2 (continued)
STEP 3:
ADJUST WIDTH OF DEVICE (IF NECESSARY)
IMPORTANT:
Loosen knobs only enough to allow plate to slide. Do not over loosen.
STEP 4:
ADJUST FOR LENGTH / POSITION OF TOE PLATE
• Loosen knob at base of sliding mechanism
and slide toe plate forward or back to proper position.
• NOTE: Toe plate should rest under base of toe when fit for
dorsi-flexion, and over top of base of toe when fit for plantar-flexion.
STEP 5:
ADJUST SIDE TO SIDE ALIGNMENT OF TOE PLATE
• Loosen knob directly under toe plate.
• Slide toe plate to left or right along rod
until positioned in comfortable
alignment with toe.
STEP 6:
ADJUST HEIGHT POSITION OF TOE PLATE
• Loosen knob on the vertical adjustment
slot of the metal upright, and slide toe
plate up or down so that it is in solid
contact with toe.
• Secure the two gray
foam straps across
forefoot, comfortably
snug. Make sure foot is
in firm contact with
foot plate with no lifting.
• Loosen knobs on
undersurface of foot
plate.
• Slide silver base plate
to left or right as
needed, so that there
is adequate space
between metal upright
and side of toe joint.
5
6
4