Reassembly - Master Trimmer MT Tumbler 200 Manual De Uso

Finally, remove the bottom cover. To do this, place the trimmer (A) part parallel to a flat surface, rotate the two
1 1
positioners 90° and pull them towards the outside to remove them.
Clean the blade (top and bottom sections), the main trimmer part (rear) (A) and the hopper (C) with hot
1 2
water under pressure using a water jet pressure washer. Wash the barrel with hot water. Never apply
pressure to it as this could damage it (do not use the pressure washer). Then disinfect all the parts men-
tioned and the command component with Master Clean (D) (THE ELECTRICAL MODULE MUST NOT BE
CLEANED WITH WATER UNDER ANY CIRCUMSTANCES). To clean the leaf collector (B), take out the leaf
leaves or other residues using gloves. Wash the bag (K) with hot water. Ensure that the turbine the entry
and outlet port are always clean to prevent any obstructions.
CLEAN WITH WATER UNDER PRESSURE AND
MASTER CLEAN (D) FOR DISINFECTION.

Reassembly

Reinsert the lower cover. Rotate the positioners
1
90° and ensure they are well placed.
90°
22
90 °
DO NOT CLEAN BY APPLYING PRESSURE
90°
90 °
X
Insert the blade. Put it in place and turn
2
the two positioners 90° for your safety.
It's very important to ensure that the
blade is correctly anchored and is held
firmly.
90°
90°