PALSON Geiser Modo De Empleo página 15

PROBLEM
The machine does not begin
operating.
The pump stops
There are large pressure fluctuations
The machine does not reach
operating pressure
This pistol trigger does not work
Thank you for demonstrating your trust in us by choosing one of our products.
POSSIBLE CAUSE
Plug disconnected
Defective outlet
Defective extension cord
Incorrect power supply voltage
Turned off
Grounded protective device (in the
case it is used) is shot
Overheating due to deficient water
supply
Partially blocked nozzle
Blocked/wilted nozzle
Insufficient water supply
Compressed intake hose
Obstructed water filter
Blocked intake hose
Safety latch activated
CORRECTION
Connect the outlet
Try another outlet
Replace the extension cord
Check that the power supply
voltage matches the machine's
specifications.
Activate the machine
Restore the grounded protective
device.
Check the water intake flow volume
– the hose should fill a bucket with
10 liters in a minute
Clean the dirt from the nozzle with a
needle and rinse from the front side
Clean/replace the nozzle
Check the intake water volume
Straighten the hose
Clean the filter
Check if there are hose leaks or
blockages
Release the safety latch
15