Inserting A Memory Card; Recording Video - ION Air Pro WIFI Guia De Inicio Rapido

Charge your camera with either the USB cable or AC/DC adapter. The red LED lights up to indicate the
camera is charging and turns off as soon as the camera has been fully charged. It takes about 3 hours to fully
charge the camera.

2.2 Inserting a Memory Card

Insert a MicroSD card (not included) before using your camera. Assure that the camera power is turned OFF
before inserting the card to the slot.
Notes
1. There is only one correct direction to insert the MicroSD card into the slot. Do not force the card into the
card slot as it may damage both the camera and the MicroSD card.
2. A new MicroSD card should be formatted before using. For more information, please see section 4.1 and 4.2
2.3 Set up Date and Time
Connect your camera to a computer and run the ion software from the MicroSD card folder. You can set date
and time on the camera through the settings page. Please see section 4.1 to open ion software
2.4 Sealing Your Camera
The Waterproof Housing lets the camera perform up to 10 meters or 30 feet
under water. You must seal the camera with PODZ in order to protect the
camera when using it in wet or moist conditions.
To secure the PODZ
1. Attach the PODZ to the back of the camera and rotate clockwise until
two dots are aligned
2. Slide the latch on the PODZ to lock it.
Notes
1. Failure to properly seal your camera can result in leaks that damage or
destroy your camera. Your warranty does not cover water damage
resulting from user damage.
2. The rubber seal on the PODZ forms the waterproof barrier to protect the
camera in wet and underwater conditions. You must keep this seal clean
as a single strain of hair or grain of sand can cause a leak into the
product.
3. After every use in salt water, you will need to rinse the outside of the
product and the seal with non-salt water and dry. Not doing this can
cause corrosion in the product or failure in the seal, in turn, damaging
the product.

2.5 Recording Video

Before starting recording, select the video resolution by switching the Video Resolution Switch
There are two methods available for starting the video record function. When starting a video recording, a short
vibration indicates recording started. The LED indicator illuminates RED throughout the recording.
EN-3