Connecting Cables - Vivotek SUPREME FE9181-H Guía De Instalación Rápida

Connecting Ethernet Cable
& the Power and IO Cable
Connect the supplied power & IO cables if your
switch does not support PoE. Connect the white
header connectors to J12 and J7 on the camera.

Connecting Cables

If you need to route cables through the side opening, proceed with
the following:
1. Connect the Ethernet and the Power & IO cables. The Ethernet cable
is user-supplied.
2. Use an included cable tie to secure the Ethernet and IO cable to the base plate. Insert the cable
tie through the vertical mounting tab located on the edge of the cabling cutout.
3. Make a clearance between cables and the vertical mounting tab. Arrange the cables neatly to
avoid getting in the way when the dome cover is attached.
4. Cut the extra length from the cable tie.
If you route cables through a drill hole on
a wall/ceiling, simply route cables through
the cabling cutout.
Strain relief boot
Make a clearance
between cables and
the vertical tab
It is recommended to remove the strain relief boot if your Ethernet cable
comes with one.
Power & IO Cable
Ethernet
Power and IO
cables
EN - 4
J12
J7