Reset Central Unit Default Code - Fermax 2405 Manual De Instrucciones

Minicentral MDS Digital
Minicentral MDS Digital
Reset DEFAULT code in central unit
How to restore the default codes (if installer has changed the access code and forgotten it):
1. With the central unit running, set switch 4 of SW1 to the ON postion. Central unit
keeps running as usual unless the power supply is turned off and on again, in which
case it will enter language update mode.
2. Enter code A708B9 from any outdoor panel with keypad.
3. The "Current Code" message comes up and after a few seconds the default codes are
restored (maintenance and installer).
4. Leave switch 4 in the OFF position.
NOTE:
Do not forget to set switch 4 in the OFF position because if there is a power cut Do not forget to set switch 4 in the OFF position because if there is a power cut
Do not forget to set switch 4 in the OFF position because if there is a power cut Do not forget to set switch 4 in the OFF position because if there is a power cut Do not forget to set switch 4 in the OFF position because if there is a power cut
or if the or if the central unit performs a Reset it will go into software updating mode central unit performs a Reset it will go into software updating mode
or if the or if the or if the central unit performs a Reset it will go into software updating mode central unit performs a Reset it will go into software updating mode central unit performs a Reset it will go into software updating mode
(LEDs X and Y blinking) and therefore will not work properly (LEDs X and Y blinking) and therefore will not work properly (LEDs X and Y blinking) and therefore will not work properly. . . . . (LEDs X and Y blinking) and therefore will not work properly (LEDs X and Y blinking) and therefore will not work properly
Pag 13