1 1
Now attach the N Tray/Handle to the other G End
Panel With Holes, feeding the ends of the molded-in
bolts through the top holes in the End Panel and then
snapping it into place. NOTE: this WILL require a
rubber mallet or hammer with a block of wood; take
care not to mar or dent the plastic. It may also be
helpful to have a second person to hold the Tray/
Handle in position while doing this.
G
13
Attach the two R Brackets by inserting two Q Long
Thin Bolts through O Small Washers, then through
the Brackets, and through the holes in the side of the
G End Panel With Holes. Place another O Small
Washer over the end of both Long Thin Bolts, and
fasten loosely with P Small Nuts. Next insert a S
Short Thin Bolt through another O Small Washer and
then UPWARD through the top of one Bracket and
into the threaded insert on the bottom side of the
Tray/Handle. Tighten both long and short bolts, but
DO NOT OVERTIGHTEN. Repeat with the second
Bracket, toward the other side of the Tray/Handle.
THREADED
INSERT
O
P
HOLE
R
5330-37: 4 of 4; Rev. 1: 10/01
N
Q
O
S
Safco Products Company, New Hope, MN 55428
12
Place a O Small Washer over one of the bolts
from the Tray/Handle extending into the recess of
the End Panel, as shown, and add a P Small Nut,
finger-tight. Repeat with three more Small Washers
and Small Nuts on the remaining bolts. Now
tighten all nuts with a 10mm socket or open end
wrench. DO NOT OVER-TIGHTEN.
14
To provide a flat surface for transporting wide
objects or to allow sliding onto or off of the shelf,
lift the Side Rails slightly, pull outward slightly, and
drop the Side Rails down until they engage the lip
on the Shelf edge.
To form a basket for keeping objects on the Shelf,
reverse the procedure until the bottom edge of the
Side Rail is in the lip of the Shelf edge.
FLAT TOP SHELF:
Top lip of side rail
in lip of shelf edge
P
O
BOX TOP SHELF:
Bottom lip of side rail
in lip of shelf edge
