Height Adjustment - Drive PreserveTech Manual Del Usuario

6. Push armrests (A) into the
armrest holders (B). If not
using armrests, skip this step.
7. Slide body (D) of raised toilet
seat onto adjustable holders (J)
until you hear a click into place.
The raised toilet seat can be adjusted using the adjustable holders (J) for an elevation
of 2" (5cm) 4" (10.1cm) and 6" (15.2cm). If you wish to change the seat height, follow
these steps:
1. Push the locking tabs on the right and left under the armrests (A) and pull the
body (D) of the raised toilet seat up.
2. Pull out the adjustable holders (J) and set the desired height. To do this insert
the rear support (I) into the corresponding hole in the adjustment holder (J).
Be sure that the adjustable holders (J) are set at the same height on both the left
and right sides.
3. To adjust the height in the front, insert the supports (K) into the corresponding
openings until you hear them click into place. Be sure that the supports (K) are
set at the same height on both the left and right sides.
NOTE: The supports (K) can be set lower than the rear support (I).
4. Set the body (D) of the raised toilet seat back onto the rear support (I).

height adjustment

A
D
J
B
J