LIGHT FOR LIFE
1. Charging the battery in the electronic module of
"LIGHT FOR LIFE". To charge, use any Smartphone
Micro USB charger. The red light indicates
charging, the battery is fully charged when the red
light goes off. Full charging time is approximately
1.5 hours.
2. Using a screwdriver, gently remove the cover on
the lower back of the helmet.
3. Insert the electronic module of the "LIGHT FOR
LIFE" into the guides, making sure the inside
connection-pin is on the same side as the
corresponding hole in the module.
4. Push the electronics module gently until it seats
at the bottom.
5. Check that the light (fixed-position) works. To do
this, place the selector lever in the fixed position.
(second position of the lever).
6. Once verified as operational, re-mount the cover.
Battery: 350 mAH. LED intensity: 60 mA
Battery life in fixed position: 7 h. (approx.)
Battery life, brake position: 100 h. (approx.)
Full-charge time: 1.5 h.
The use of device "LIGHT FOR LIFE" is the exclusive and sole responsibility of the user.
BRAKE SWITCH
1. Remove the taillight of the bike.
2. Locate the brake light wire of the bike
3. Connect BRAKE LIGHT cables to the rear brake
light of the vehicle, positive (red) to positive, and
negative (black) to negative.
4. Put the "LIGHT FOR LIFE" module in the brake
position, turn-on the ignition of the vehicle and
check that the application of the brakes of the
vehicle causes the helmet light to illuminate. 2
5. Re-assemble, and you may then drive the vehicle.
