Technical Parameters; Other Information - Elko EP ZSR-30 Manual De Instrucciones

Technical parameters

Entry (U prim)
Supply voltage:
Input without load (max):
Input with load (max):
Supply voltage tolerance:
Output (Usec)
Output voltage:
Output voltage-no load AC:
Output voltage-no load DC:
Fuse (in primar winding):
Wave of output voltage:
Effi ciency:
Tolerance of output voltage:
Towards black-out and
Electronic fuse:

Other information

Operating temperature:
Storing temperature:
Electrical strenght (prim/sec):
Protection degree:
2
Max. cable size (mm ): solid wire max.1x 2.5 or 2x 1.5 / with sleeve max.1x 1.5 (AWG 12)
Dimensions:
Weight:
Standards:
WARNING!
Values of max. load are valid for (operational) temperature.
ZSR-30 ZNP-10-24V
AC 230 V / 50 - 60 Hz
9 VA / 2.5 W 9 VA / 2 W
11.5 VA / 8 W
-15 %; +10 %
DC 5-24 V stab.
DC 24 V nonstab. DC 24 V nonstab.
AC 24 V AC 24 V
32 V
44 V
primary wind T100 mA
300 mV max. 3 V
75 % x
±5 % x
current overloading x
-20.. +40°C (-4 °F to 104 °F)
-20.. +60°C (-4 °F to 140 °F)
4 kV
IP40 from front panel / IP20 terminals
90 x 52 x 65 mm (3.5˝ x 2˝ x 2.6˝)
398 g (14 oz.) 368 g (13 oz.)
EN 61204-1, EN 61204-3, EN 61204-7
Warning
Device is constructed for connection for 1-phase main alternating -current voltage and
must be installed according to norms valid in existing state. Connection according to
the details in this direction.IInstallation, connection, setting and servicing should be
installed by qualifi ed electrician staff only, who learn this instruction and functions of
device.For right device protection should be fronted-end certain element. Before start-
ing installation must be main switch in position "SWITCH OFF" and device should be out
of voltage. Don´t install device to suppliers surcharge electro-magnetic interference. By
right installation of device is provide good air circulate to don´t pass maximal operat-
ing temperature,in case of higher ambient temperature and permanent working. For
installation and setting use screw-driver cca 2 mm. The device is full-electronic - installa-
tion should be eff ected according to this. Function without problems is too dependent
on previous type of transportation, storing and manipulation. In case of any vestige of
destruction, deformation, non-function or missing part, don´t install and made claim to
seller. Product may be ,after passing operating time, disassemled, recycled or puted on
protected tip.
2 / 2