Idiomas disponibles
Idiomas disponibles
01- Adjust the articulating set (4) on the
wall according to your preference. Note
that when the support articulation is
closed, the plates are centralized.
03-
Fix the screw anchor on the wall, screw
the six spots of the support.
articulating screws are pointing up (A)
05
03
05 - Fix right and left tilting sets (02 and 03)
with the Plasma in the upright position
using the basic set of screws (05), placing it
centralized as much as possible.
15
02- In the base of the articulating set there
are 6 orifices (2 round and 4 oblong); for
the oblong orifices certify that the marks on
the wall are made in the center of each one,
for a later level adjustment.
A
04- Screw the plasma support plate (1) on
the plate of the articulating set on four
Certify that the
indicated spots usingAllen Screws (6).
Certify that the side cut on the plate (A) is
facing forward.
02
06 - Note that the edges with round orifices
must be pointing up and the wing locking
nuts of the tilting set must be turned out.
A A
