Internal Hygrostat Operation; External Hygrostat Operation; Hour Counter - Dantherm CDT 30 MKII Manual De Servicio

User guide,
Internal hygrostat
operation
External hygrostat
operation

Hour counter

8
cont.
The table below shows operation of the hygrostat function and display texts.
Step Key
Press HYG SET RHxxx% - will flash for 5 seconds. The dehumidifier will
and then switch to internal hygrostat controlled operation with set point
hold (once the set point is reached, the display will show INT HYG STOP)
Press +/- briefly to set the RH% value in during the above 5 second
period. The new value will be saved after a further 5 second period
after the last key is pressed
Press HYG OFF - will flash for 5 seconds. The dehumidifier will then switch
to constant
If an external hygrostat is connected, the machine will automatically switch over to us-
ing it
Any adjustment of the set point must now be made on the external hygrostat. (once the
set point is reached, the display will show EXT HYG STOP)
The built in hour counter logs the total number of operating hours (cannot be reset) and
the number of hours left until the next service, which can be adjusted. The service hour
counter is disabled upon delivery.
Step Key
Press SERVICE xxxxh – shows the number of hours to the next au-
and thorised service. This value is saved automatically after 5
hold seconds of flashing, and the function will activate if not al-
ready activated. When the set number of hours for service in-
tervals has expired, the display will switch to SERVICE
Press +/- briefly to set a new service value. The new value
will be saved 5 seconds after the last key is pressed
Press SET SERVICE OFF – deactivates the service timer function
Feedback
Feedback
Continued on next page