Ideal 52 Instrucciones De Instalación

Conectores de palanca (lever)
Idiomas disponibles
  • ES

Idiomas disponibles

Enlaces rápidos

Installation Instructions - Lever Push-In Wire Connectors
Models 52, 53 & 55
• Do not exceed the rating of these connectors
• Turn OFF power before removing or installing connectors
• Wiring must comply with all applicable electrical regulations
• COPPER TO COPPER ONLY. Do not use on aluminium wire.
• Incorrect use of these connectors can cause electrical fires, personal injury or death
• Use only one conductor per port
• Strip wires back 9 – 10mm
• For solid and rigid stranded wire, grip wire firmly and insert conductor into open port
(lever does not need to be open)
• For flexible stranded wire (>7 strands) lift lever and insert conductor into open port. Close lever
• Verify conductors are fully inserted to the back of the connector.
• To remove a wire, lift lever and pull out wire
Strip Length
Specifications
Rating
Depth
Width
Height
Wire Combination Range
Insertion
Solid, Rigid Stranded and Flexible
Wires
www.idealindustriesemea.com
Model 52 2-Port
Model 53 3-Port
24 Amp / 450V / 120°C
11.9 mm
Removal
Model 55 5-Port
21 mm
16.1 mm
11.7 mm
0.2mm-2.5mm2
24.5 mm
1/5
loading

Resumen de contenidos para Ideal 52

  • Página 4 Instrucciones de instalación - Conectores de palanca (lever) Modelos 52, 53 & 55 • No superar la potencia nominal de los conectores • Apague la alimentación antes de instalar o quitar conectores • Los cables deben cumplir con todas las normativas eléctricas aplicables •...

Este manual también es adecuado para:

5355