RoboCam ZC15 E Guia Del Usuario página 8

To Change which group of 4 cameras you want buttons C1, C2, C3,and C4 to control :
1. To make buttons C1 thru C4 control cameras 5-8 (instead of 1 thru 4) move the switch at the
bottom from Normal to Program, press C2 then move the switch back to Normal.
2. To make buttons C1 thru C4 control cameras 9-12 move the switch from Normal to Program,
press C3 then move the switch back to Normal.
3. To make buttons C1 thru C4 control cameras 13-16 move the switch from Normal to Program,
press C4 then move the switch back to Normal.
6. Trouble shooting
You do not receive any picture on your TV :
- Check that the selected channel (A, B, C, D) of your camera is identical to your receiver 's
- Check that the power switch of the receiver is ON
- Check that your camera is well inserted in its power supply, and that the whole is plugged into a
standard socket
You get a poor quality picture
- Move the antenna of the camera and the Receiver. Normally they should point at each other
- Select another channel (A, B, C, D) for your camera and your receiver
The camera gradually drifts off the positions you have programmed
This happens if the positions you programmed do not cause the camera to pass through center. In
that case, press the Center button on the remote to reset the positions to where you programmed
them. Or you can make the camera periodically center automatically as follows :
Within 3 seconds after you plug the camera's power supply in, press P1, P2, P3 or P4 on the
remote.
- Pressing P1 within 3 seconds after you power up forces the camera to recenter every 32
sweeps through the positions you have programmed.
- Pressing P2 within 3 seconds after you power up forces the camera to recenter every 64
sweeps through the positions you have programmed.
- Pressing P3 within 3 seconds after you power up forces the camera to recenter every 128
sweeps through the positions you have programmed.
- Pressing P4 within 3 seconds after you power up forces the camera to recenter every 256
sweeps through the positions you have programmed.
To cancel the above automatic centering:
While the camera is recentering, move the switch on the remote control to Program, press Sweep,
and then move the switch back to Normal.
To stop the camera from ever recentering automatically:
Press any Blue key to stop the camera sweep. Unplug the camera's power supply, plug it back in,
and (within 3 seconds) press Center.
Page 7