Basic Operations - SOUNDMASTER PL560 Manual Del Usuario

CONTENT OF DELIVERY
 Main unit
GETTING STARTED
This system is designed to operate on normal 230V 50Hz AC only.
Attempting to operate from any other power source may cause damage
to the system, and such damage is not covered by your warranty.
NOTE
: If this plug will not fit into your outlet, you probably have an
outdated non-polarized AC outlet. You should have your outlet
changed by a qualified licensed electrician.
ERP power management
The unit will turn off automatically after 15 minutes in standby mode if there is no audio
signal. To turn on the unit again switch the unit off and on again.
POWER ON / OFF
Turn the "Power On / Off" knob clockwise to turn the unit on, the power indicator will light up.
Turn the "Power On / Off" knob anti-clockwise to turn the unit off, the power indicator will turn off.
SELECTING MODES
Slide the "Function switch" to the desired function (PHONO / TUNER / AUX).
ADJUSTING VOLUME
Rotate the "Volume Control" knob to desired volume level.
MANUAL TUNING
1. Turn the unit on and slide the "Function switch" to the "TUNER" position.
2. Tune to requested radio station with the "Tuning knob", and select FM or FM-Stereo with
the "FM / FM Stereo" switch.
3. Adjust the volume with the "Volume Control" knob to desired volume level.
FM & FM-STEREO RECEPTION
 Set the "FM / FM Stereo" switch at "FM" position. Radio stations are received in FM mono
mode. In particular when stereo signals are weak. It is preferable to receive the program in
mono mode.
 Set the "FM / FM Stereo" switch at " FM-ST " position for receiving stereo program. The FM
Stereo LED indicator will light up to show FM stereo program is receiving
HINTS FOR BEST RECEPTION
The receiver has a built-in FM wire antenna hanging at the rear cabinet. This wire should be
totally unraveled and extended for best reception.
INSTALLATION

Instruction Manual

BASIC OPERATIONS

RADIO
2
PL560 / English Instruction Manual
AC Plug AC Outlet