Creasol Four Guia De Inicio Rapido

Creasol Four
Long range 433.92 MHz
universal remote control
Copies up to 4 existing
remote controls for gates,
garage doors, traffic barriers, ...
Operating 433.92 MHz
frequency: modulation OOK
Effective Radiated -5dBm ERP max
Power:
Power supply: 27A
(12V 20mAh)
Current in TX: 12 mA
In stand-by 0 µA
Operating -10°C ÷ +55°C
temperature:
EN DE
IT FR
Made in EU
Related products
Creasol UniLock: electric lock activator that opens the
entrance doors or gate door by using
almost any existing remote control.
Fits everywhere!
Very easy to be instalLed: only 2
wires that should be connected in
parallel to the existing switch.
Creasol UniRec1:
receiver with one opto-insulated
output. Suitable to activate an
electronic board (garage door or gate
opener) by using almost any existing
remote control in the market.
Creasol UniRec2:
with 2 relay outputs, 250Vac 5A capability.
Outputs are independent and can be configured in hold-
to-run, bistable, bistable ON/OFF (1 remote control
button to activate output, another button to disable
output) and timer from 500ms to 1 hour.
Our receivers work with almost any remote control in the market, AM and FM,
fixed and rolling code, from 433.42 to 868.8 MHz and from 288 to 418 MHz.
Creasol Four
Long range 433.92 MHz
universal remote control
Copies up to 4 existing
remote controls for gates,
garage doors, traffic barriers, ...
Operating 433.92 MHz
frequency: modulation OOK
Effective Radiated -5dBm ERP max
Power:
Power supply: 27A
(12V 20mAh)
Current in TX: 12 mA
In stand-by 0 µA
Operating -10°C ÷ +55°C
temperature:
EN DE
IT FR
Made in EU
Related products
Creasol UniLock: electric lock activator that opens the
entrance doors or gate door by using
almost any existing remote control.
Fits everywhere!
Very easy to be instalLed: only 2
wires that should be connected in
parallel to the existing switch.
Creasol UniRec1:
receiver with one opto-insulated
output. Suitable to activate an
electronic board (garage door or gate
opener) by using almost any existing
remote control in the market.
Creasol UniRec2:
with 2 relay outputs, 250Vac 5A capability.
Outputs are independent and can be configured in hold-
to-run, bistable, bistable ON/OFF (1 remote control
button to activate output, another button to disable
output) and timer from 500ms to 1 hour.
Our receivers work with almost any remote control in the market, AM and FM,
fixed and rolling code, from 433.42 to 868.8 MHz and from 288 to 418 MHz.
Creasol Four
433.92 MHz universal
remote control duplicator
Copies existing remote controls for gates,
garage doors, traffic barriers, ...
Long range and light weight
C r e a s o l
only creative solutions
http://www.creasol.it
Creasol Multi
universal compact
Multi-frequency
remote control
duplicator.
433 and 868 MHz
universal multi-frequency receiver
Creasol Four
433.92 MHz universal
remote control duplicator
Copies existing remote controls for gates,
garage doors, traffic barriers, ...
Long range and light weight
C r e a s o l
only creative solutions
http://www.creasol.it
Creasol Multi
universal compact
Multi-frequency
remote control
duplicator.
433 and 868 MHz
universal multi-frequency receiver
ENGLISH
Introduction: this device is able to copy several types of remote control for gates,
garage doors, traffic barriers, which transmit in the frequency 433.92 MHz AM/OOK.
Each button is independent, so it's possible to clone up to 4 different remote controls.
Duplication:
1. Press together buttons 1 and 2, until Led turn from red to solid green.
2. Release all buttons.
3. Press and release the button where you wish to copy the original remote control.
4. Start to transmit by pressing and holding the button on the original remote control,
keeping in touch on the duplicator.
When duplication ends, Led flashes 2 times in case of fixed code, or 4 times in case
of rolling code: in the latter case, it might not work. Then Led becomes green and
duplication procedure restarts from point 3, permitting to copy other remote controls
quickly. To check duplication, each button should be pressed at least 2 times to assure
that the gate or garage works correctly.
Programming a new random fixed code:
random fixed code on one or more buttons, even in different frequencies:
1. Press together buttons 3 and 4, until Led turn from red to solid green.
2. Release all buttons.
3. Press twice the button where you wish to program a new random code.
The remote control emits 2 flashes, then it's possible to initialize a new random code
on another button restarting the procedure from point 3.
Battery status and replacement: If, during transmission or duplication, Leds blink
between red and green, the battery voltage is low: in this case the temperature is low
or the battery is almost flat. In the latter case, the enclosure should be opened,
inserting and twisting the flat tip of a screwdriver into the slot on bottom-left corner
(FourST), or unscrewing the 2 screws on the back (Four); pick up the board and
replace the existing battery with a new alkaline battery 12V type 27A (Four) or 23A
(FourST)
Safety instructions: keep the battery well out of reach of children and animals; call a
doctor immediately if the battery is swallowed. The battery should never come in
contact with other metallic objects to avoid discharge, damage and burn. Do not use
near locations which are sensitive to radio interference, like aircraft and hospitals.
Disposal: product and battery cannot be disposed as household waste, but must be
disposed of correctly or returned to the seller when purchasing a new equivalent
product. Heavy fines can be imposed by local laws for illegal disposal.
Warranty: the warranty complies with statutory requirements, and covers only
defect in material, workmanship or lack of conformity. Your local stockist should be
contacted in connection with any warranty-related matters. Battery is not covered by
the terms of the warranty.
CE Declaration of Conformity: this remote control meets the essential requirements
of the European Directive 1999/5/EC (R&TTE).
Applied standards: EN 300 220, EN 301 489, EN60950, EN62479.
Declaration of Conformity can be optained from http://www.ce.creasol.it
ITALIANO
Introduzione: questo dispositivo consente di duplicare numerosi tipi di
radiocomandi per apricancello, basculanti, barriere, che trasmettano nella frequenza
433.92 MHz AM/OOK.
Ogni tasto è gestito in modo indipendente, cosicché è possibile clonare fino a 4
radiocomandi anche se di tipologia diversa.
Duplicazione:
1. Premere contemporaneamente i tasti 1 e 2 finché il LED diventa verde.
2. Rilasciare i tasti.
3. Premere e rilasciare il tasto su cui si vuole memorizzare il radiocomando originale.
4. Portare in trasmissione il radiocomando originale, tenendolo in contatto sopra il
radiocomando duplicatore.
La duplicazione si conclude con l'emissione di 2 lampeggi nel caso di
memorizzazione di un codice fisso, oppure 4 lampeggi nel caso di un rolling code: in
quest'ultimo caso potrebbe non funzionare.
A questo punto il LED diventa verde e la procedura di apprendimento riparte dal
punto 3, consentendo la duplicazione veloce di altri radiocomandi.
Dopo la memorizzazione, è necessario testare ciascun tasto più volte per verificarne il
corretto funzionamento.
Programmazione di un nuovo codice fisso
consente di impostare un codice casuale su uno o più tasti (non serve per la
duplicazione di un radiocomando):
1. Premere contemporaneamente i tasti 3 e 4 finché il LED diventa verde.
2. Rilasciare i tasti.
3. Premere il tasto in cui si vuole inizializzare un nuovo codice.
Il radiocomando emetterà 2 lampeggi e la procedura ripartirà dal punto 3.
Stato della batteria e sostituzione:
lampeggiano entrambi i LED (verde e rosso), la batteria risulta quasi scarica. Per
aprire il contenitore, fare leva con un cacciavite sulla feritoia in basso a sinistra
(FourST) oppure svitare le due viti (Four). Sostituire la batteria con una nuova pila
alcalina tipo 23A (FourST) oppure 27A (Four).
Norme di sicurezza: conservare le batterie fuori dalla portata dei bambini; in caso di
ingestione chiamare subito un medico. La batterie non devono venire a contatto con
altri oggetti metallici, i quali potrebbero scaricare, incendiare o danneggiare il
prodotto. Non azionare il radiocomando in luoghi sensibili alle emissioni radio
(aeroporti, ospedali, ...).
Smaltimento: il prodotto e la batteria non possono essere smaltiti nei rifiuti
domestici, ma negli appositi centri di raccolta, oppure restituiti al venditori qualora si
acquisti un nuovo prodotto equivalente. Sono previste sanzioni in caso di
smaltimento non conforme alla legge.
Garanzia: conforme alle disposizioni di legge, copre difetti, interni al dispositivo, sui
materiali e sul processo produttivo. Il referente per eventuali prestazioni in garanzia è
il rivenditore. Il diritto di garanzia è applicabile solo per il paese in cui il prodotto è
stato acquistato. La batteria non è inclusa nella garanzia.
Dichiarazione di conformità CE: questo dispositivo soddisfa i requisiti essenziali
della Direttiva Europea 1999/5/EC (R&TTE).
Norme applicate: EN 300 220, EN 301 489, EN60950, EN62479.
La Dichiarazione di Conformità può essere prelevata da http://www.ce.creasol.it
follow the instructions below to set a new
random: la procedura sottoriportata
se durante la trasmissione o la duplicazione