Cleaning And Maintenance - Kiwi KFAN 7640 Manual Del Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
USE
• SPEED+/- (speed): it cycles in the sequence of low - mid - high - low.
• TIMER (timer): it cycles in the sequence of 0.5H-1H-2H-4H.
• MIST (mist): for use, see the paragraph: Humidify function.
• MODE (mode): it cycles in the sequence of Normal wind - Natural wind - Sleep wind - Normal wind.
• OSC (oscilation): it controls the left and right swinging.
Humidify function
• Remove the water tank from the host, and unscrew the water tank cap counter-clockwise.
• Fill the water tank with cold water, tighten the water tank cap and check for leakage.
• As is shown, put the water tank into the host according to the angle, and wait a few minutes until the
host sink is filled with water.
• After the humidify button is pressed, the indicator lights up to start humidify.
• Note: If the indicator flashes (off after 10 seconds), it indicates insufficient water or low water level,
please check whether the float in the sink of the host has floated or the water tank is properly placed.
• NOTE: Always drain the main unit before transport. Remove the spring clamp and drain plug, and
clear the machine of the remaining water.

CLEANING AND MAINTENANCE

• Before cleaning or maintenance, switch off the appliance and remove the mains plug from the wall
socket.
• Remove the spring clamp and drain plug, and clear the machine of remaining water.
• If scale occurs, use a small amount of detergent and clean with clear water after soaking for about
30 minutes.
• Mount the drain plug and spring clamp.
• To ensure adequate air circulation to the motor, keep vents at the rear of the motor free of dust.
• Please wipe the exterior parts with a soft cloth soaking a mild detergent, do not use any abrasive
detergent or solvents to avoid scratching the surface.
8
Tabla de contenido
loading

Tabla de contenido