Idiomas disponibles
Idiomas disponibles
Upright
Pole
1" Coupling
#8 Set
Screw
1
5
Front
Hole
3
Mounting
Bracket
2
Clamp Knob
Step 1
• Secure Coupling between two upright poles and secure with 2 Set Screws. (Repeat for other set)
Step 2
• Remove top Hex Nut from Clamp Knob assembly, insert into notch in Mounting Bracket, insert Clamp
Knob into hole in bottom of Mounting Bracket and thread Clamp Knob up through Hex Nut.
Step 3
• Slide the Mounting Bracket over the top rail of pool as shown. Place Block Support between
underside of rail and clamp knob bolt and tighten.
Step 4
• Insert Eyelet into the top holes on the Upright Pole Support and fasten with Washer and Hex Nut.
(Repeat for other side)
Step 5
• Insert the Upright Pole into the 1
Step 6
• Extend the Net across the pool, pull tight and tie top Net Ropes to the top of each pole through the
Eyelets. Net can be shortened by rolling on pole or lengthened by extending the Rope Ties.
Step 7
• Tie bottom Net Ropes to the bottom of each pole and through the front hole in the Mounting Bracket.
Step 8
• Tie two 8' ropes to the Eyelet at the top of the Upright Pole and extend diagonally to tie around pool
top rail, as shown. (Repeat for other side)
6
Cap
Net
Net
Tie
#8 Set Screw
Block
Support
7
Rope
Hex
Nut
Notch
Pool Upright
Support
8
/
'' hole in the Mounting Bracket, secure with set screw. (Repeat for other side)
1
8
Upright Pole Detail
Hex Nut
Washer
4
Mounting Bracket Detail
Front
Hole
Pool
Top Rail
Pool Wall
Notch
with Hex
Nut inserted
Pool
Top Rail
Eyelet
Block
Support
Hex Nut
Clamp Knob
with threaded stud
poolmaster.com
2
