MikroTik BaseBox Serie Manual De Instrucciones

BaseBox series
The Basebox is a solid and waterproof outdoor device based on the RB912 wireless router model. It has high
power wireless and one Gigabit Ethernet connector, which support MDI-X auto detection. The device has two
RPSMA connectors for connecting external antennas. The device is packaged with a power adapter, a PoE injector,
and two mounting loops. Extra places for more RP-SMA connectors are available on the unit in this case.
First use
1. Choose your powering solution, please see
2. Remove the lid, and connect the antenna to the RP-SMA connectors. Bend the cable with a large radius,
so that it will be able to exit through the cable openings in the bottom of the lid. Put the lid back, with the
small arrow to the front of the case.
3. Open the device bottom door, to reveal the Ethernet connector.
4. Connect your direct input power jack if not using POE, to start up the device.
5. Connect your Ethernet cable to the Gigabit Ethernet port.
6. The device will boot up and after short beep Wireless network will be available for connecting.
7. Open network connections on your pc, mobile phone or other device and search for MikroTik wireless
network and connect to it.
8. Once connected to the wireless network, open http://192.168.88.1 in your web browser to start
configuration, since there is no password by default, you will be logged in automatically.
9. We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest
version to ensure the best performance and stability.
10. Choose your country, to apply country regulation settings and set up your password in the screen that
loads.
Mounting
The device can be mounted in several ways: wall, ceiling, pole. To tighten the device to a pole, use the provided
metal hose clamp. Guide the loop around the device through the provided holes, and around the pole where it will
be mounted. You should avoid connecting a loose Ethernet cable to the Ethernet port, secure the cable to a wall or
the pole, so that the cable weight is not pulling the port. It is recommended to secure the Ethernet cable less than
2m from the device. This is to ensure that the cable doesn't damage the port by its weight, or doesn't fall out. It is
possible to connect grounding wires to the PCB board mounting holes, but to do this, you must remove the PCB
from the case.
Warning! This equipment should be installed and operated with a minimum distance of 380 cm between the device
and your body. Operation of this equipment in the residential environment could cause radio interference.
Powering
The device accepts power from the power jack or from the Ethernet port:
Direct-input power jack (5.5mm outside and 2mm inside, female, pin positive plug) accepts 24 V DC.
•
Ethernet port accepts passive Power over Ethernet 18-57 V DC (Please compensate voltage for loss due
•
to cable length)
The power consumption under maximum load can reach 12 W. For BaseBox 6 model up to 23 W.
Configuration
RouterOS includes many configuration options in addition to what is described in this document. We suggest
starting here to get yourself accustomed to the possibilities: http://mt.lv/help. In case IP connection is not available,
the Winbox tool (http://mt.lv/winbox) can be used to connect to the MAC address of the device from the LAN side
(all access is blocked from the Internet port by default).
For recovery purposes, it is possible to boot the device from the network, see a section
See mikrotik.com/products for the latest version of this document.
Powering section for possibilities.
Reset button.
Document #49326 Modified on: 16.MAY.2019