AVer M90UHD Guía Rápida página 9

 To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Warranty will be
void if any unauthorized modifications are done to the product.
Do not drop the camera or subject it to physical shock.

 Use the correct power supply voltage to avoid the damaging camera.
 Do not place the camera where the cord can be stepped on as this may result in fraying or damage to the
lead or the plug.
Hold the bottom of the camera with both hands to

move the camera. Do not grab the lens or flexible
arm to move the camera.
Do not move the camera head over 110° to avoid

camera head wear.
FEDERAL COMMUNICATIONS COMMISSION
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference when the
equipment is operate din a commercial environment. This equipment generates, uses, and can radiate radiofrequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Warning:
This is a class A product. In a domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures.
COPYRIGHT
©2020 AVer Information Inc. All rights reserved.
WARNING
Do not pull the mechanical arm and camera part

in the opposite direction.
Do not pull the mechanical arm lower than 60° to

avoid camera wear.
English-7