Tern Hub Axle Skewer Manual De Instrucciones página 3

2
4
4. Ensure that the threaded end of Skewer Rod is nearly flush with, but does not protrude past the outer surface of Anti-Rotation Nut.
5. When tightening, if the threaded end of Skewer Rod is not close to the outer surface of Anti-Rotation Nut, it may be necessary to remove one
or both Washers. Repeat steps 1-4 until the Skewer Rod's threaded end is nearly flush with, but not protruding past the outer surface of Anti-
Rotation Nut. (Note: Each Washer is 1 mm thick.)
To function properly, all inside threads of the Anti-Rotation Nut must be engaged with the Skewer Rod.
3
2. A part of the Anti-Rotation Nut extends from the base of the nut.
Please note that this protrusion needs to be positioned in the
dropout opening, as shown.
3. Tighten Hub Axle Skewer to a torque of 6-8 Nm.
EN
ES
FR
IT
JP
TC
SC
KO
DE
3