Eldom miix R100 Manual De Instrucciones página 11

Assemble the attachments in the order shown in the photo 2. Insert the flanged ending
into the socket marked on the housing of the body (4) with the symbol
- before the operation make sure that all the components were assembled properly
- plug in the appliance
- the mixer starts its operation after a proper speed is selected with the switch (2).
By changing its position 5 different speeds can be obtained.
TURBO button is used to achieve immediately the maximum speed corresponding to the
position "5" of the switch (2)
When whisking or mixing is finished, one should:
- slide the switch (2) to "0" position and unplug the mixer;
- pull the attachments from the sockets by pressing the button (1)
CAUTION
Watch the continuous operation time of the appliance. The extended operation time and
the lack of breaks may lead to the irreversible damage to the engine and loss of warranty.
In the case of stopping the appliance while operation, before cleaning, unplug it and wait
till the attachments stop to whirl.
If the appliance slows down while operation it needs a break and, if possible, liquefying
ingredients.
3
photo
BLENDER OPERATION
- before connecting the blender (7) make sure the appliance is unplugged and the switch
(2) is set in the position "0"
- remove the housing (8) in the back part of the body of the mixer (4)
- insert the blender (7) on that position and turn it clockwise, photo 3
- plug in the appliance
- the mixer starts its operation after a proper speed is selected with the switch (2).
After pressing the "TURBO" button (3) we obtain the maximum speed.
When the appliance is no longer used, set the switch (2) in the position "0" and unplug the
appliance.
Disassemble the blender (7) by turning it counter clockwise.
Blender knife is an operating component and is not covered by the warranty
EN|11