LIMIT 1300 H Manual Del Usuario página 4

English
Start. Press
key. The laser always starts with automatic self-leveling. The laser beam and
X-indicator blinks while self-leveling is in progress. X-indicator lit green when setup is
complete.
Automatic self leveling. The instrument stops and blinks when it knocked out of his position and
will restart automatically rotate after the new self-leveling.
Manual Slope mode. Press 3 seconds
key. X-indicator and Tilt-indicator lit green
continuously. Tilt the laser beam along the X axis with buttons. The laser will
rotates regardless of inclination.
Tilt mode. Is a safety feature to prevent the instrument automatically restart after having been tilt
out of position and possibly then changed altitude. Press key, the Tilt lit green
continuously. If the laser will be tilted it will stop, Tilt-indicator will blink and sound signal starts.
The laser must be restarted. Check the altitude level after restart to the altitude before the
stoppage.
Calibration. Check the laser. Place the laser about 20 m from a wall and direct the X1 axis
towards the wall. Start laser. Mark X1 level on the wall. Rotate the laser 180 without altitude
⁰
change. Mark the X2 level. The difference between X1 and X2 may be less than 2.5 mm at 20 m
1.8
distance. Repeat the check with Y1 and Y2 axis.
Calibration. Simultaneously press and keys. Release and after 4 seconds when
Y-indicator blinks once and X-indicator blinks green and release . Now adjust the X axis
with keys to correct position between the earlier marks on the wall. Rotate the laser
90 , press key. Y indicator is blinking and is ready for adjustment of Y axis. Adjust the Y
⁰
axis with keys. Save the calibration, press again key. Make a new check
before use.
Batteries. Connect the charger to 230 V and the jack on the instrument panel side. The battery
charger's LED lit red when charging process and green when fully charged. Recharge approx 4
hours. Operating time approx 18 hours per charge. Indicator "BATT" blinks when the battery runs
low and should be recharged. At too low battery capacity stops the laser to rotate and start blinks.
The battery capacity is affected by temperature.
Laser Receiver. Assemble the detector to the holder with the threaded bush on back of the
receiver when to be used with a level rod. Battery 9 V type 6F22.
Power on or off. Automatic off after no laser beam received or key operation for 10
minutes.
3