How To Stop; Before Starting Break-In Procedure; Before Each Start-Up; How To Start - Craftsman 919.166700 Manual Del Usuario

How to Use Your Unit

How to Stop

:
1. Set the On/Auto/Off lever to "OFF".
Before Starting
Break-in Procedure
Serious damage may result if the
following break-in instructions
are not closely followed.
This procedure is required before the air compres-
sor is put into service and when the check valve or
a complete compressor pump has been replaced.
1. Make sure the On/Auto/Off lever is in the "OFF"
position.
NOTE: Your unit could be damaged if the pressure
switch lever is in the ON/AUTO position.
B E
C
D
2. Plug the power cord into the correct branch cir-
cuit receptacle. (Refer to Voltage and Circuit
Protection paragraph in the Installation section
of this manual.)
3. Open the drain valve fully (counter-clockwise) to
permit air to escape and prevent air pressure
build up in the air tank during the break-in peri-
od.
4. Move the On/Auto/Off lever to "ON/AUTO" posi-
tion. The compressor will start.
5. Run the compressor for 15 minutes. Make sure
the drain valve is open and there is minimal air
D23012
All manuals and user guides at all-guides.com
6. After 15 minutes, move the On/Auto/Off lever to
7. Move the On/Auto/Off lever to "ON/AUTO" posi-

Before Each Start-Up:

1. Place On/Auto/Off lever to "OFF".
2. Pull regulator knob out, turn counter-clockwise
3. Attach hose and accessories. See the Portable
G

How to Start:

1. Turn the On/Auto/Off lever to "AUTO" and allow
F
2. Pull the regulator knob out and turn clockwise
NOTE: Always operate the air compressor in well-
ventilated areas free of gasoline or other com-
bustible vapors. If the compressor is being used to
operate a sprayer DO NOT place near the spray
12 - ENG
pressure build-up in tank.
"OFF" position and close the drain valve (clock-
wise).
tion. The air receiver will fill to "cut-out" pres-
sure and the motor will stop.
until it stops. Push knob in to lock in place.
"Quadraport" Control Panel paragraph in this
section.
Too much air pressure
causes a hazardous risk of
bursting. Check the manufacturer's maximum
pressure rating for air tools and accessories.
The regulator outlet pressure must never exceed
the maximum pressure rating.
tank pressure to build. Motor will stop when
tank pressure reaches "cut-out" pressure.
to increase pressure. When the desired pressure
is reached push knob in to lock in place. The
compressor is ready for use.