Ada CUBE 2-360 Green Manual Del Usuario página 5

English 5
If the switch (5) is OFF, that means that the line laser is off, the compensator
is also locked.
3. Press button (1) to switch the vertical beam on. Press button (1)once again
to switch the horizontal beam on. Press button (1) to switch the horizontal
and vertical beams on. Switch on only necessary laser lines in order to save
battery life
.
4. Press button (2). The mode "outside" is activated. Press button (2) once
again. The tool begins to operate in "inside" mode. Use the detector of laser
beam for this mode. See the operating manual for the operation with detector.
TO CHECK THE ACCURACY
3
TO CHECK THE ACCURACY OF LINE LASER (SLOPE OF PLANE)
Place the line laser on the tripod 5m away from the wall so the horizontal
laser line will be directed to the wall.
Switch on the power. The line laser starts to self-level. Mark point A on the
wall to show the contact of laser beam with the wall. Turn the line laser by
90° and mark points В, С, D on the wall. Measure distance "h" between the
highest and lowest points (these are A and D points in the picture).
If "h"is ≤ 6 mm, the measurement accuracy is good. If "h" exceeds 6 mm,
apply service center.
TO CHECK PLUMB
Choose a wall and set laser 5m away from the wall. Mark point A on the
wall, please note the distance from point A to ground should be 3m. Hang
a plumb line from A point to ground and find a plumb point B on ground.
turn on the laser and make the vertical laser line meet the point B, along
the vertical laser line on the wall and measure the distance 3m from point
B to another point C. Point C must be on the vertical laser line, it means the
height of C point is 3m.
Measure the distance from point A to point C, if the distance is over 2 mm,
please, contact with seller to calibrate the laser.