Hubbell CFB2GS1R6ADAPT Guia De Inicio Rapido

16. Orient cover support collar [13] as required by removing and reinstalling screws [14]. Lap joint in collar defines the
hinge location of the cover (SEE FIGURES E & F).
17. Install finished flooring to within 1/8 inch [3.2 mm] of cover support collar [13]. FOR CERAMIC TILE - DO NOT GROUT
BETWEEN THE SUPPORT COLLAR AND TILE.
18. Adjust height of cover support collar flush to just below the finished floor. Cover support collar is adjustable for
finished floors of 0 inches to .25 inches [0.0 - 6.4 mm] thick. Tighten mounting screws [14] to 10 - 15 lbs-in torque
[1.1 - 1.7 N-m]. For thicker floor finishes use accessory collars (CFB6RCVRR series), sold separately.
19. Seal the gap around the cover support collar [13] with a continuous bead of electrical grade type RTV silicone sealant
(SEE FIGURE G).
20. Use the provided floor gasket or apply a 1/4 inch [6.3 mm] thick continuous bead of electrical type of RTV silicon
sealant compound fully around the perimeter on the underside of the flange [15].
21. Attach flange [15] to the cover support collar [13] using #8-32 flat head screws [16] provided with the cover.
13
14
(HINGE SIDE)
LAP JOINT
(HINGE SIDE)
FIGURE F
FIGURE G
13
LAP JOINT
16
15
FIGURE E
SEAL ALL AROUND
CFB2GS1R6ADAPT ROUND COVER ADAPTER FOR 2 GANG RECESSED
CONCRETE FLOOR BOX Installation Instructions
CAUTION: RISK OF ELECTRICAL SHOCK. Disconnect power before installing or servicing.
NOTICE: For installation by a qualified electrician in accordance with all national and local electrical codes,
communications standards, the following instructions and any instructions included with individual devices.
NOTICE: Insure data/communications circuits are separated from lighting/power circuits in accordance with the NEC and
CE Code requirements.
Use with CFB2G25, CFB2G25CR, CFB2G30, or CFB2G30CR floor boxes.
Use with CFBS1R6CVRxx series round covers or CFBS1R6FFCVRxx series round furniture feed covers.
BEFORE CONCRETE POUR, SEE FIGURES A, B, & C
1. Remove four #8-32 flat head screws [1] from top corners of floor box assembly and discard.
14
2. Remove mounting plate [2] from the box.
3. REMOVE AND DISCARD PLASTIC [3] AND METAL [4] COVERS ATTACHED TO THE MOUNTING PLATE [2].
4. Install leveling screws [5] as shown in FIGURE A.
5. Make conduit connections in accordance with application and applicable electric codes. 2" trade size conduit hubs,
(CFBHUB2), sold separately, may be used in place of knockout plates [6] as needed (CFB2G30 and CFB2G30CR only).
Wiring Device - Kellems
Hubbell Incorporated (Delaware)
40 Waterview Dr.
Shelton, CT 06484
1-800-288-6000
www.hubbell-wiring.com
PD2595
04/14
3
4
1
2
6
5
FIGURE A
ENGLISH