Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The following wires are for the aftermarket radios that have navigation built in.
• Connect the Light Green wire to the parking brake wire.
• Connect the Blue/Pink wire to the VSS or speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
From the LD-AX-ADFD01 harness:
(a) 22-pin harness to the aftermarket radio:
The DIN plug is to be connected to the optional AX-LCD screen (sold separately)
if SYNC information is shown on the OE radio.
• Connect the Red wire to accessory power if the AX-LCD screen will be used.
(b) 24-pin harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the antenna turn-on wire.
Only perform the following step for the Ford Expedition.
• Connect the Blue/White wire to the amp turn-on wire (if populated on factory side).
These wires are to be connected if the vehicle does not have the SONY/THX system.
• Connect the Violet wire to the right rear positive wire.
• Connect the Violet/Black wire to the right rear negative wire.
• Connect the Green wire to the left rear positive wire.
• Connect the Green/Black wire to the left rear negative wire.
AX-ADFD100
Connection to be made
12-pin pre-wired ASWC-1 harness:
3
(c) 16-pin harness to the aftermarket radio:
• Connect the RCA jacks labeled "RSE/SYNC/SAT" to the
audio AUX-IN jacks on the aftermarket radio (if retaining
rear seat entertainment, SYNC, or satellite radio).
Note: Most Ford radios have SAT built in, so this feature is lost if so.
• Connect the RCA jacks labeled "From 3.5" to the audio AUX-IN
jacks on the aftermarket radio (if SYNC is not present).
(d) 8-pin harness to the aftermarket radio:
• If the vehicle is equipped with a factory amp, connect the White
RCA jack to the sub out jack on the aftermarket radio.
• If the vehicle is equipped with a SONY/THX amp, connect the Red RCA
jack to the center channel out jack on the aftermarket radio/processor.
Note: If this jack is not present on the aftermarket radio, just leave be.
Only the center channel speaker will be lost.
This harness is to be used in along with the optional ASWC-1 (not included) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard
this harness. If it will be used, please refer to the ASWC-1 instructions for radio
connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
Tabla de contenido
