Installation Instructions - AquaSource AT1203-00 Manual Del Usuario

1. Install Floor Bolts
NOTE: Inspect existing floor flange for damage. If it
is damaged, replace the flange before proceeding.
Insert floor flange brass bolts (AA) into the toilet flange (not
included) with bolt heads down and threaded ends facing up.
(Bolts should be parallel to wall and 6 in. apart.)
2. Install Wax Ring
Turn bowl (B) upside down onto a cushioned surface. Place
wax ring (MM) over the raised outlet ring of the bowl (B).
Press firmly and slightly twist wax ring (MM) against bowl (B)
so the wax adheres to the bowl (B).
NOTE: If wax ring has an integral plastic flange, be
sure flange taper points away from the toilet.
3. Position Bowl on Floor Flange
Unplug floor flange (if necessary). Gently lower the bowl (B)
into position with the floor flange brass bolts (AA) protruding up
through the holes in the base of the bowl (B).
NOTE: Keep the bowl level as it is lowered onto the
floor flange. You may need a second person to help lift
the bowl.
Once bowl (B) is in position, press down with a slight
twisting motion on the top center of the bowl (B), eventually
applying full body weight to evenly compress the wax ring
(MM) to create a watertight seal. Make sure the bowl (B) is
as level as possible.
CAUTION: Do not rock the bowl back and forth as
this may break the seal.
TIP: It may be necessary to use small wedges or
shims (not included) under the edge of the bowl due
to slight variations in vitreous chinaware or uneven
floors. Bowl should be firmly seated on the floor so
it does not wobble or rock.

INSTALLATION INSTRUCTIONS

AA
B
B
AA
3
Floor
Flange
MM
Floor
Flange