abc L-Desk Guia De Instalacion página 7

Step 3
Flip the DRAWER UPRIGHTS over.
å
Separate the EXTENSION SLIDES (GG) from the EXTENSION RAILS (FF) as shown in the upper diagram. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (FF) to the DRAWER UPRIGHTS (P and Q). Use six BLACK 1/2" PAN HEAD SCREWS (19).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other two holes that lines up with the hole in the UPRIGHT. Turn a
SCREW into these holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Open end
Use these holes to fasten the
EXTENSION RAIL to the part.
FF
FF
P
Finished edge
Push the black lever down and pull the SLIDE from the RAIL.
Q
Edge with
small holes
Just think. The sooner
you do this, the sooner
you do something else.
GG
Open end
FF
Finished edge
19
BLACK 1/2" PAN HEAD SCREW
(6 used in this step)
Page 7