ASROCK J3160TM-ITX Manual De Instrucciones página 17

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 25)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Analog Surround
Audio Header
(17-pin HD_AUDIO2)
(see p.1, No. 28)
3W Audio AMP Output
Wafer Header
(4-pin SPEAKER1)
(see p.1, No. 27)
GN D OUT2_L
J_SENSE
PRESENCE# OUT2_R
MIC_RET
MIC2_R
OUT_RET
MIC2_L
1
PIN
18
16
14
12
10
8
2 1
6
4
2
1
Front_L-
Front_L+
Front_R+
Front_R-
This header is for
connecting audio devices
to the front audio panel.
Signal
PIN
Name
SENSE
17
LFE
15
A_GND
13
Surr_Rear_R
11
A_GND Surr_Rear_L
9
Surr_Side_R
7
A_GND Surr_Side_L
5
Front_R
3
A_GND
1
Please connect the chassis
speaker to this header.
J3160TM-ITX
Signal
Name
KEY
A_GND
Center
A_GND
A_GND
A_GND
Front_L
15