Timer Mode - Champion cooler Ultracool CP35 Manual De Instrucciones

Enfriador evaporativo portátil
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Install Casters
This unit comes equipped with 4 stem casters; 2 locking and 2 non-locking. Before operation turn the unit
on its side and press the stem casters into the corner holes. Install the locking caster on one side of the unit
and the non-locking casters on the opposite side.
Fill With Water
To fill this unit with water, open the water access door and fill with a pitcher or
water hose (see fig. 1). Do Not Overfill.
Water Level Indicator
On the front of the unit there is an access window to view the water level in-
dicator (see fig. 2). When the unit is full of water, the level indicator will show
mostly blue. As the level of the water is decreased in the unit, the blue on the
indicator will diminish.
Power To Unit
Note: This unit comes equipped with a remote control. The buttons on the
remote function the same as the controls on the unit. Refer to the control
panel in figure 3 for the following instructions.
When the unit is plugged in, the power indicator on the display will be red.
Pressing the power button will start the unit in Fan-High mode. The power
indicator on the display will now be blue. The pump will not start until the
pump button is pressed.
Pump / Cooler Operation
To operate this unit as an evaporative cooler, the unit must be filled with wa-
ter and the pump powered on. Press the pump button to turn on the pump.
The water drop indicator on the display will flash while the pump is on. To
operate the unit as a fan only, press the pump button to turn off the pump.
Note: The pump will not run if the water level falls below a certain level. When the water level drops
below this level, an audible alarm will sound and the "Low Water" indicator on the display will flash on and
off. The audible alarm will stop after 60 seconds or when the pump button is pushed. The indicator will
remain flashing until the unit is filled with water. You will need to restart the pump by pressing the pump
button after the unit is refilled with water.
Fan Operation
Pressing the fan speed button on the control will cycle the
fan speed from Low to Mid to High. The speed setting
will be highlighted in the display, showing 2, 4 or 6 bars.
Oscillate Mode
Pressing the oscillate button will oscillate the verti-
cal vanes back and forth. The oscillate indicator on the
display will be displayed when on. Press the button again
to turn off.

Timer Mode

This unit is equipped with a timer. You may set the time interval for the unit to stay on. Pressing the timer
button will set the time interval in 1/2 hour increments up to 12 hours. The display will flash while setting
the time and will be solid once it is set. The display will count down the time remaining in 1/2 hour incre-
ments. When the time interval is reached, the unit will turn off.
Cooler Installation
Operation
2
Low Water Indicator
Oscillate
Timer
Pump
Water
Access
Door
Fig. 1
Water Level
Indicator
Fig. 2
Power
Fan
Fig. 3
Tabla de contenido
loading

Tabla de contenido