Getting Ready To Laminate - GBC FUSION 5100L Manual De Instrucciones

GB

getting ready to laminate

Easy Set Up
1 Remove the plastic exit tray from the box and place into the two holes on the back of the
laminator and extend to use. Ensure that there is sufficient space behind the laminator for the
item to be removed.
2 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
3 The laminator will briefly flash the GBC logo on the control panel and will make an audible beep.
4 To use the laminator gently tap the 'power on' button.
NOTE: Your new laminator may emit
a slight odour during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
Interactive Menu Selection
5 A GBC logo will show in the screen followed by the main menu:
MANUAL SELECT
SETTINGS
NOTE: Use arrows to scroll up/down and left/right, use ENTER
button to select.
Use at anytime to go back – one screen at a - time to the
main menu.
Manual Select (
NOTE: If 40mic setting is selected
ALWAYS use a carrier
6
register this product online at www.accobrands.com
AUTO POUCH SELECT
HELP
) – scroll through and select the required micron setting, i.e. 75mic.
40 mic
75 mic
125 mic
175 mic
250 mic