Europlast eextra EK Serie Manual De Instrucciones página 45

Installation and Maintenance
Caution! Before installation, disconnect the power network where you are
planning on installing the fan.
Caution! Installation may be carried out only by a qualified electrician.
The fan must be installed in the ventilation duct (Drawing 1). Base model fans, fans with a timer (T), fans with
bearing (B), fans with timer and bearing (TB) shall be connected to the power network. To do that, remove the
cap by turning it counter clockwise and pressing off the latch with a flat-blade screwdriver at the same time
(Drawing 2). Under the lid, there is either NL or SNL terminal that shall be connected to the power network in
accordance with the connection diagrams (Drawing 3 - 5).
When connecting the fan to electricity, it is important to take into account polarity and connect the live wire to
the Terminal L and the neutral wire to the Terminal N.
In case if the fan is directly connected to the electric power network, the power network must be equipped with
a switch that ensures safe disconnection of the power supply.
Bearing B
In addition, the fan is equipped with two ball bearings inside of the electric motor.
Timer T
The fan is turned on by the S1 power switch (Drawing 4) or by turning on the light (Drawing 5). After turning
off the light or the switch, the fan continues its operation for a specific time interval that is set up by a controller.
This interval may be 0 to 30 minutes long.
Timer and Bearing TB
The fan is equipped both with a timer and bearing function. For more information on the timer and bearing
functions, see section Timer T and Bearing B .
Caution! Fans with electronic control unit must be adjusted before they are connected to the power
network.
Caution! If the potentiometer is set to "0 min", the fan will turn on for a couple of seconds after
connected it to the power network.
Guarantee
Producer guarantee is 24 months.
In the case of damages contact the place of trade.
The guarantee does not cover:
1. noted mechanical or other damages
2. mechanical or other damages caused by incorrect or improper usage, misuse, abuse or neglect
3. mechanical or other damages caused by incorrect installation or by product's incorrect fitting to
insufficient or unsuitable power
4. mechanical or other damages caused by ignoring the instruction manual conditions
A guarantee does not cover natural wear of the product.
Information for Users on Disposal of Old Equipment. This symbol indicates that the electrical
and electronic equipment should not be disposed of as general household waste at its end-of-
life. Instead, the products should be handed over to the appliance collection points for the
recycling of electrical and electronic equipment, recovery and recycling in accordance with
your national legislation and the Directive 2002/96/EC and 2006/66/EC.
45
EN