Kenwood AW45001 Manual Del Usuario página 5

GB
Your new Power Whisk has been
fitted at the factory with a plain shaft
as shown in Figure A. However, your
mixer may not be compatible with
this design and you may need to
change the shaft for the additional
one supplied.
Please look at the bowl tools
supplied with your mixer and check
which type of shaft is fitted. If the
shaft has a clip as shown in Figure B,
you will need to replace the shaft on
the Power Whisk. Using a spanner
loosen the nut on the shaft
then turn the shaft anti-clockwise
until it is released. Replace with the
shaft with the clip fitted and tighten
the nut.
Adjust the height of the Power whisk
using the following procedure. For
best performance the whisk should
be almost touching the bottom of
the bowl .
1 Unplug the mixer.
2 Raise the mixer head and insert
the whisk.
3 Lower the mixer head. If the
clearance needs to be adjusted
raise the mixer head and remove
the whisk.
4 Using a spanner loosen the nut
sufficiently to allow adjustment of
the shaft
closer to the bottom of the bowl,
turn the shaft anti-clockwise. To
raise the whisk away from the
bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
and 6 Fit the whisk to the mixer and
lower the mixer head. Check its
position
7 Repeat the above steps as
necessary until the whisk is set
correctly. Once this is achieved
tighten the nut securely.
●
Designed and engineered by
Kenwood in the UK
●
Made in China
2
. To lower the whisk
.