Metz SCA 3302 M7 Manual De Instrucciones página 37

The initialising procedure has to be repeated
after the mecablitz has been switched off
(including Auto-Off in connection with meca-
blitz 40 MZ-...) and on again.
The remote set-up (controller and slave) is ready
for shooting pictures after initialisation has been
successfully completed!
Automatically controlled light output "Ratio":
The automatically controlled light output "Ratio"
divides the share of light in a ratio of 1/3 and 2/3
between the flash units.
System-inherent reasons do not permit the
Ratio Mode with Dimage ....
"Ratio" mode with the camera's built-in flash
and a slave flash unit:
The setting procedure for the camera, controller
and slave is the same as for the normal remote
mode. One-third of the light output is assigned to
the camera's built-in flash (controller). For this pur-
pose keep the flash button on the camera de-
pressed during shooting (see the operating instruc-
tions for the given camera). The remaining
two-thirds are assigned to the slave flash unit
(mecablitz). The mecablitz must be in slave mode
and ready for firing.
The display of "rA1" and "rA2" on the meca-
blitz is only of significance when two slave
flash units are used.
The camera's built-in flash unit can be re-
placed by a Minolta flash unit 5400xi / 5400HS
/ 3600HS(D) / 5600HS(D). For the settings on
37