Davin DV-101D Manual De Instrucciones página 7

9. Now press the OK button
10. Using the two buttons on the left, select
channel
11. Now press the OK button.
* The display will now show DAY SELECTION.
12. The button on the left can be used to select
(flashing) the different days (above in
display).
The button alongside can be used to confirm
your selection (flashing stops).
Now press the OK button (this will now be
flashing).
13. Setting the start time for powering on (e.g.
start at 8.00 a.m.)
You can set the times (power-on command)
by using the two buttons on the left.
Now press the OK button.
14. Duration (eg 5 sec signal):
You can set the hours/min/sec e.g. for a
school bell by using the two buttons on the
left (power-on command).
Now press the OK button.
1.6.2 PROGRAMMING THE CHANGEOVER
TIME IN MINUTES
The DV-101D now functions as a normal
standard digital time clock.
* Pressing (briefly) the ESC button will
take you back 1 step in the programming
process.
1. Press the menu button 1x
2. Using the two buttons on the left, select
PROGRAM
3. Now press the OK button
4. Using the two buttons on the left, select
NEW
DV-101D Binnenwerk PMS.indd 7
Manual DV‑101D
5. Now press the OK button
6. Using the two buttons on the left, select
7. Now press the OK button
8. Using the two buttons on the left, select
9. Now press the OK button
10 Using the two buttons on the left, select
11 Now press the OK button.
*
12. The button on the left can be used to select
13. Now press the OK button (now flashing).
14. The two buttons on the left can be used to
15. Now press the OK button.
16. Repeat the actions in steps 14-15 until
1.6.3 SETTING THE SWITCH CYCLE
Consult the factory manual.
1.7
Consult the factory manual.
1.8
The DV-101D has a 6 Amp thermal fuse.
This fuse disables the DV-101D on its own
during an overload and / or short-circuits.
When the thermal fuse has turned off the
DV-101D (during an overload and / or short) the
DV-101D can be reset.
VACATION / WEEKLY
ON / OFF
channel
The display will now show DAY SELECTION.
(flashing) the different days (above in
display).
The button alongside can be used to confirm
your selection (flashing stops).
set (channel on) the times (minutes).
STORED is shown in the display.
You have now finished programming the
DV-101D.
REMOVING THE SWITCH COMMANDS
THE FUSE OF THE DV-101D
9
28-3-2012 2:18:46