Uline H-2813 Manual De Instrucciones
  1. Manuales
  2. Marcas
  3. Uline Manuales
  4. Esparcidores
  5. H-2813
  6. Manual de instrucciones
Uline H-2813 Manual De Instrucciones

Uline H-2813 Manual De Instrucciones

Ocultar thumbs
1
2
3
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-2813
ICE MELT SPREADER
TOOL NEEDED
Pliers
NOTE: Read all directions prior to assembly. This
spreader comes partially assembled. Control
rod installation will require pliers.
• Spreader is designed to be pushed at three miles
per hour, which is a brisk walking speed. Slower or
faster speeds will change the spread patterns.
• Prior to first use, coat all metal parts (inside and
outside) with a spray lubricant to help prevent
corrosion.
• Clean spreader thoroughly after each use. Wash
with clean water and dry thoroughly. Spray a light
coating of oil on all metal parts (and inside all of the
tubing) to help prevent corrosion.
• Gears are permanently lubricated at the factory.
Do not open the gearbox or dirt may enter.
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
1.
2. Install control rod into handle as shown above.
3. Rotate forward.
4. Insert control rod into pivot and secure with hair pin
5. Assembly is complete. Set the stop on the control
Pour le français, consulter la page 3.
Remove spreader from carton and pull handle into
position shown below. Tighten wing nuts to secure.
(See Figure 1)
Figure 1
Control Rod
clip.
assembly for the desired setting and your spreader
is ready to operate.
Para Español, vea página 2.
Hair Pin Clip
0621 IH-2813
loading

Manuales relacionados para Uline H-2813

Resumen de contenidos para Uline H-2813

  • Página 1 Para Español, vea página 2. Pour le français, consulter la page 3. H-2813 1-800-295-5510 uline.com ICE MELT SPREADER TOOL NEEDED Pliers INSTRUCTIONS Remove spreader from carton and pull handle into NOTE: Read all directions prior to assembly. This spreader comes partially assembled. Control position shown below.
  • Página 2 H-2813 800-295-5510 uline.mx ESPARCIDOR DE DERRETIDOR DE HIELO HERRAMIENTA NECESARIA Pinzas INSTRUCCIONES Saque el esparcidor de la caja y jale el asa para NOTA: Lea todas las instrucciones antes del ensamble. El esparcidor viene parcialmente colocarlo como se muestra abajo. Apriete las ensamblado.
  • Página 3 H-2813 1-800-295-5510 uline.ca ÉPANDEUSE DE DÉVERGLAÇANT OUTIL REQUIS Pince INSTRUCTIONS Retirez l'épandeuse de la boîte et déployez la REMARQUE : Lisez toutes les instructions avant l'assemblage. Cette épandeuse est poignée de la manière illustrée ci-dessous. Serrez livrée partiellement assemblée. Des pinces les écrous à...