Revell Control BIG ONE PRO Manual De Instrucciones página 8

1. StARtiNG PREPARAtioNS:
The speed controller (left controller of the remote control) must point downwards when switching on the helicopter in
order to avoid an unwanted start. Now set the ON/OFF-switch of the remote control to „ON". Carefully plug the cable for
the flight operation onto the helicopter. Set the ON/OFF-switch of the helicopter to„ON". Place the helicopter on the floor
at a distance of 1-2 metres from you so that the tail points in your direction. The remote control requires approximately
5 seconds to synchronise with the helicopter. Afterwards you can start by moving the speed control slowly from its lower
position. If necessary also set the thrust trim to the lower position.
2. tRiMMiNG tHE coNtRoLS:
Correct trimming is the basic prerequisite for correct helicopter flight characteristics. It is easy to align the helicopter, but requires patience and sensitivity.
Please observe the following guidelines precisely: Move the actuating regulator carefully upwards to make the helicopter move approximately 0.5 to 1 metre upwards.
if the helicopter turns quickly or
slowly to the right by itself ...
If the helicopter automatically rotates quickly or slowly to the right, turn the left/right
fine tuning in an anti-clockwise direction until the helicopter no longer rotates.
the helicopter flies
forward by itself...
If the helicopter flies forward by itself move the nod trim backwards until the helicopter
no longer flies forward.
the helicopter climbs
by itself...
If the helicopter climbs by itself move the thrust trim backwards until the helicopter no
longer climbs.
8
Flying the helicopter
Roll trim:
if the helicopter continues to drift to one side when flying, try to correct this by moving the roll trim dial in
the opposite direction to the way the helicopter is drifting.
if the helicopter turns quickly or
slowly to the left by itself ...
If the helicopter automatically rotates quickly or slowly to the left, turn the left/right fine
tuning in an anti-clockwise direction until the helicopter no longer rotates.
the helicopter flies by
itself backwards...
If the helicopter flies by itself backwards move the nod trim forwards until the helicopter
no longer flies backwards.
The helicopter descends
by itself...
If the helicopter descends by itself move the thrust trim forwards until the helicopter
no longer descends.
2m distance