Vaisala AP10 Guía Rápida página 9

2. Point the antenna up or down for best wireless performance.
3. Connect the Ethernet cable.
4. If the Ethernet cable does not provide power, connect the DC power supply:
a. Connect the plug to the power supply connector of AP10. Make sure the plug is
oriented correctly and goes in all the way.
b. Rotate the power plug slightly to lock it to the connector.
c. Connect the power supply to the wall socket.
5. Secure the power supply so it does not fall or hang on its cable.
6. Wait for the access point to start up. Verify from the touchscreen that the access point is
fully connected and no errors are shown. Make sure installation mode is still enabled if you
want to connect new data loggers.
If the message Not connected to NTP is shown on the display, see
Troubleshooting NTP connections (page 11)
resolve time server connection problems.
for instructions on how to
9