Craftsman CMECSP610 Manual

Manual CMECSP610 Rework Kit / Juego de Reconstrucción CMECSP610 Manual
Fig. A
Fig. C
Fig. E
Fig. G
Fig. B
Fig. D
Fig. F
ENGLISH
1
ASSEMBLY

WARNING: IMPORTANT – Install parts in numerical order. The parts are numbered one
through three.

WARNING: IMPORTANT –To be assembled on the cord from the chain saw. Do not install on
the pole or the connector cordset end.

WARNING: Be sure saw plug is clean and free of debris.
2
The parts in the plug collar kit are numbered one through three as shown in Figure A. Locate the
number on the part and install the parts in numerical order.
Install Part One (Fig. B)
1. Install part one onto the chamfered corners
Failure to install part one onto the chamfered corners will result in the upside down assembly
of the collar to the plug.
2. DO NOT install part one onto the rounded corners. See Figure B for chamfered and rounded
corners 2 .
3. Match part one to the edges of the plug. The edges of the chainsaw plug slip inside the
groove of part one.
Install Part Two (Fig. C)
1. Install part two onto the plug as shown in Figure C. Failure to install part two during this step
will result in the nonfunctional assembly of the collar.
2. DO NOT install part three during this step. Part two and part three look very similiar.
3. The plug sits securely in part two.
NOTE: DO NOT force part two onto the plug.
Remove Part One (Fig. D)
1. After securely installing part two, remove part one as shown in Figure D.
2. DO NOT disturb part two while removing part one.
3. If part two is disturbed during removal of part one, begin assemblage again starting with
Install Part One.
4. Discard part one. It is no longer required for Assembly
Install Part Three (Fig. E, F, G)
1. Install part three as shown in Figure E. Ensure the hooks of part three snap into the grooves of
part two. The snaps should be flush and engaged as shown in Figure F.
2. The adapter should completely encase plug as shown in Figure G.
a. Part two should sit flush against the rounded corners of the plug.
b. Part three should sit flush against the angled corners of the plug.
c. Misalignment of either part will cause the collar to fail.
d. In case of misalignment, begin assemblage again starting with Install Part One.
3. Install screw until seated. Do not over tighten.
WARNING: To reduce the risk of injury, read the
instruction manual.
AVERTISSEMENT : afin de réduire le risque de blessures, lire
le mode d' e mploi de l' o util.
ADVERTENCIA: Para reducir el riesgo de lesiones, lea el
manual de instrucciones.
1 of the chainsaw plug as shown in Figure B.