Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.
Connect the hoe coupling to the pressure washer.
Before connecting the male coupling remove the
plastic cap from the device coupling which was
installed for transport. Once the male coupling has
been connected, Connect the garden pressure hose
using a hydraulic quick coupler. Connect the garden
hose to a water source and fully open the valve.
3
4
MSW-PRW1400WB
1.
Attach the extension pipe to the gun. Press in
and turn the extension pipe clockwise until tight.
When these elements are connected correctly, it is
impossible to disconnect them by pulling in opposite
directions.
2.
Insert adjustable spray nozzle to the extension
pipe. Press in and turn the spray nozzle clockwise.
When these elements are connected correctly, it is
impossible to disconnect these two parts by pulling
in opposite directions.
A turbo nozzle may be used instead of an adjustable
spray nozzle. To that end insert the turbo nozzle into
the extension pipe analogously to the adjustable
spray nozzle. Select a nozzle best suited for the
surface to be cleaned. For the gun to function
properly, connect all the necessary elements. Only
one nozzle may be used at a time.
1
3.
Use bolts to attach the device handle to its body.
4.
Connect the high-pressure hose to the pressurised
water inlet using a hydraulic quick coupler. When
these elements are connected correctly, it is
impossible to disconnect them by pulling in opposite
directions. To separate them, press the lock release
button and pull out the hose.
3
5.
Connect the high-pressure hose to the gun using
a hydraulic quick coupler. When these elements are
connected correctly, it is impossible to disconnect
them by pulling in opposite directions. To separate
them, press the lock release button and pull out the
hose.
12
EN
5
2
4
6.
Connect the hoe coupling to the pressure washer.
Before connecting the male coupling remove the
plastic cap from the device coupling which was
installed for transport. Once the male coupling has
been connected, Connect the garden pressure hose
using a hydraulic quick coupler. Connect the garden
hose to a water source and fully open the valve.
5
OPERATION
The device is designed for use with cold water only. Do not
use hot water with this device.
Once the device is connected to a cold-water source:
•
Make sure the IN/OFF switch is on the OFF position.
•
Make sure the device is completely assembled.
Otherwise complete the assembly.
•
Bleed the device by pressing the gun trigger for
approximately 1 minute to let the air out from the
pump and hose. Perform this operation before
connecting the device to a power source. If there
was any water in the device, it might leak slightly
from the gun.
•
Switch off the pressure washer using the ON/OFF
switch, then point at the surface to be washed and
press the trigger. Remember that the motor only
works when the trigger is pressed.
•
After use press the ON/OFF button to the OFF
position to switch the device off.
Attention! Risk of injury! When the trigger is pressed, the
device will spray a stream of liquid under pressure. High
pressure will remain in the device and the hose even after
the device has been switched off. Point the gun in a safe
direction and press the trigger in order to release the
pressurised liquid. Do not direct the liquid stream towards
people, animals, electrical equipment or cables.
GUN SAFETY CATCH
The gun features a safety catch preventing the trigger from
being pressed accidentally. When not in use, use the safety
catch to protect the pressure washer gun against activation.
Lock Unlock
Adjustable spray nozzle
The adjustable spray nozzle delivers two spray shapes: wide
spray (figure 2) or a compact spray (figure 1). For cleaning
more delicate materials as well as ships and other vehicles,
start by using a wide spray from a minimum distance of 1m
to prevent damaging the surface. Always start by pointing
towards empty space to check the stream type.
6
16.04.2020
Tabla de contenido
