Safety Information - Palmer PEBHER HERRENCHOR BASS CHORUS Manual De Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

SAFETY INFORMATION

1.
Please read these instructions carefully.
2.
Keep all information and instructions in a safe place.
3.
Follow the instructions.
4.
Observe all safety warnings. Never remove safety warnings or
other information from the equipment.
5.
Use the equipment only in the intended manner and for the in-
tended purpose.
6.
Use only sufficiently stable and compatible stands and/
or mounts (for fixed installations). Make certain that wall
mounts are properly installed and secured. Make certain that
the equipment is installed securely and cannot fall down.
7.
During installation, observe the applicable safety regulations
for your country.
8.
Never install and operate the equipment near radiators, heat
registers, ovens or other sources of heat. Make certain that
the equipment is always installed so that is cooled suffi-
ciently and cannot overheat.
9.
Never place sources of ignition, e.g., burning candles, on the
equipment.
10. Ventilation slits must not be blocked.
11. Do not use this equipment in the immediate vicinity of water
(does not apply to special outdoor equipment - in this case,
observe the special instructions noted below. Do not expose
this equipment to flammable materials, fluids or gases.
12. Make certain that dripping or splashed water cannot enter the
equipment. Do not place containers filled with liquids, such
as vases or drinking vessels, on the equipment.
13. Make certain that objects cannot fall into the device.
14. Use this equipment only with the accessories recommended and
intended by the manufacturer.
15. Do not open or modify this equipment.
16. After connecting the equipment, check all cables in order to
prevent damage or accidents, e.g., due to tripping hazards.
17. During transport, make certain that the equipment cannot fall
down and possibly cause property damage and personal injuries.
18. If your equipment is no longer functioning properly, if fluids
4
4
4
or objects have gotten inside the equipment or if it has been
damaged in another way, switch it off immediately and unplug
it from the mains outlet (if it is a powered device). This
equipment may only be repaired by authorized, qualified per-
sonnel.
19. Clean the equipment using a dry cloth.
20. Comply with all applicable disposal laws in your country. Dur-
ing disposal of packaging, please separate plastic and paper/
cardboard.
21. Plastic bags must be kept out of reach of children.
FOR EQUIPMENT THAT CONNECTS TO THE POWER MAINS:
22. CAUTION: If the power cord of the device is equipped with an
earthing contact, then it must be connected to an outlet with a
protective ground. Never deactivate the protective ground of a
power cord.
23. If the equipment has been exposed to strong fluctuations in
temperature (for example, after transport), do not switch it on
immediately. Moisture and condensation could damage the equip-
ment. Do not switch on the equipment until it has reached room
temperature.
24. Before connecting the equipment to the power outlet, first
verify that the mains voltage and frequency match the values
specified on the equipment. If the equipment has a voltage se-
lection switch, connect the equipment to the power outlet only
if the equipment values and the mains power values match. If
the included power cord or power adapter does not fit in your
wall outlet, contact your electrician.
25. Do not step on the power cord. Make certain that the power
cable does not become kinked, especially at the mains outlet
and/or power adapter and the equipment connector.
26. When connecting the equipment, make certain that the power cord
or power adapter is always freely accessible. Always discon-
nect the equipment from the power supply if the equipment is
not in use or if you want to clean the equipment. Always unplug
the power cord and power adapter from the power outlet at the
plug or adapter and not by pulling on the cord. Never touch the
power cord and power adapter with wet hands.
5
5
5
Tabla de contenido
loading

Tabla de contenido