Keep the instructions for future.
NF-EN-71
Warning! Not suitable for children under 36 months,
unstable base, fall hazard. Warning! Protective equipment
should be worn.
Not to be used in traffic. 50 kg max.
Remove the scooter and all the parts from the box. Set out all the parts
and read the assembly instructions prior to use. Keep the packaging until
assembly is complete.
General instructions
This toy must be assembled by a responsible adult. Prior to use, make
sure that the toy has been assembled properly. Remove all the parts
which are not necessary for play before giving the toy to your child. The
toy should be used with caution since skill is required to avoid falls or
collisions causing injury to the user or third parties.
To use with suitable protective equipment, including a helmet, shoes,
elbow, wrist and knee protectors. Teach the child how to use it safely and
responsibly.
Directions:
- T he scooter can be dangerous and can cause traffic accidents when
used on public highways. Don't use on the on public roads. It is best
used on a flat, clean surface, free of gravel and grease. Avoid bumps
and drainage grates that may cause an accident.
- T he scooter does not include any headlights or lights. It is therefore not
suited for use at night or during periods when visibility is limited.
- A lways use under adult supervision.
- Do not allow more than one child to ride the scooter at the same time.
Before and after use:
Make sure that all locking mechanisms are securely locked:
- C heck the height of the steering system, and make sure the nuts are
tightened and that the handlebars and the front wheel are perpendicular.
- T he minimum height of T-bar has to be locked at the lowest position by
switching the bullet into the lowest slot. (see 'E' diagram).
- C heck all of the connection elements: the brake, the steering column's
quick release system and the wheel axles must be adjusted correctly
and not damaged.
- Also check the tyre wear.
4
SCOOTER ASSEMBLY (see page 2)
Insert the handle bars into the hole at the front of the main board
between the
two front wheels while paying attention to the direction of insertion.
Ensure the spring button pops out and locks the piece properly, as
shown. (Diagram A)
PRIMO is available with 2 types of handlebars:
Height adjustable handlebar which can be adapted to the child's height.
- 3 Positions:
• Low position: 67.5 cm
• Middle position: 72.5 cm
• High position: 77.5 cm
- 4 Positions:
• Low position: 67.5 cm
• Middle position: 72.5 cm; 77.5 cm
• High position: 82.5 cm
The bullet shall be in the hole while adjusting the T-bar height.
Make sure that for the lowest position of T-bar, the bullet is locked into the
lowest slot (see 'E' diagram).
Steering: PRIMO's steering responds intuitively to the movement of the
body (Diagram B).
- When the child leans to the right, PRIMO turns right!
- When the child leans to the left, PRIMO turns left!
For the youngest children, on flat surfaces and in straight lines, PRIMO
has a steering blocking system for better balance and to make learning
easier.
- To lock, press the button above (Diagram C).
- To release, press the red button below (Diagram D).