EHEIM air pump 100 Manual Del Usuario página 10

Ocultar thumbs Ver también para air pump 100:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
When the line is damaged, the device must no longer be
used.
To protect against contact voltage being too high, the fixture
must have a residual current device with a rated release fault
current not exceeding 30 mA. Ask your electrician.
Do not clean the unit – or parts of it – in the dishwater. Not
dishwater resistant.
Do not dispose of this product as normal household waste.
Take it to your local refuse collection site.
The product is approved in accordance with the respective
national regulations and guidelines and complies with the
EU standards.
Function
a Control knob (air volume) b power supply cord c air hose d
outlet e bubble pattern f wall mountingeyelet g drip loop h anti-
skid feet and vibrationdamper i air filter.
Putting into operation
• Check the unit for damage and for completeness.
Mounting location / Positioning:
• Always install above the water level and outside the aquarium (Fig.
B) to prevent water from running back into the air pump
• Do not place on or above the aquarium. Choose the mounting location
/ positioning so that the aerator cannot drop into the water or "walk".
We recommend mounting using the wall mounting eyelet (Fig. B).
• Cut the hose c to the required length and connect the outlet d to
the aquarium aerator. Place the outlet with suction device in the
aquarium (Fig. B). If only one accessory is connected to EHEIM air
pumps 200 and 400, which are provided with two air connections,
please use a T-type connector available from your dealer. Never ope-
rate an air connection without a „load", i.e. without hose and outlet.
• Place the outlet d in the aquarium.
Tabla de contenido
loading

Este manual también es adecuado para:

Air pump 200Air pump 400370137023704

Tabla de contenido