Ebode TPC Guía Del Usario página 7

Transmitter - Wireless Remote Control
The LED will blink Red for House Code then Green for Unit Code
(the factory setting is A1: One Red blink and one Green blink),
then go to Yellow (program mode).
Go to the next step to configure the House Code and Unit Code.
After 6 seconds the modules will return to normal operation and
leave the program mode.
B. Press and release the ON key the appropriate number of times
for the House Code you want to set. Once for A, twice for B, etc.
The factory setting will be "A = 1 Red Blink"
After setting the House Code, the Yellow LED will blink 3 times,
which means the House Code is set and the module has left the
programming mode.
To set the Unit Code, start from step A but skip step B and go
directly to step C.
Stop
C. Press and release the ON key the appropriate number of times
for the House Code you want to set. Once for 1, twice for 2 etc.
The factory setting will be "1 = 1 GREEN Blink"
After setting the UNIT Code, the YELLOW LED will blink 3 times,
which means the UNITE Code is set and the module has leave the
program mode.
To configure the second row, repeat step A, B and C.
Note: When changing the battery, the address will be retained.
Operating the TPC Module
Check the address.
Briefly press the first row ON and OFF button simultaneously to check the
address. e.g. for "B3" the red LED will blink twice for the house code and then
green 3 times for the unit code.
Wait until the LED blinks yellow 3 times to show it has left the programming
mode.
The same can be done with the second row of buttons.
July 2009 page 7
Ref : TPC
TPC