Ferm Industrial CDM1142P Traducción Del Manual Original página 7

• Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on
the charger (6) will lighten up and show the
charger status.
LED indicators (6)
Fig.C
The charger has 2 LED indicators (6) which
indicate the status of the charging process:
Red LED Green LED
Charger status
status: status:
Off Off No power
Standby mode:
-No battery is inserted or,
On Off
-Battery inserted but charging has
finished more then 2 hours ago
Blinking Blinking Defective battery
On Blinking Battery charging in progress
Battery charging finished, battery
On On
fully charged
Battery is too hot, charging
progress is on hold. Charging will
Blinking Off
start automatically after the battery
has cooled down.
• Fully charging the battery may take up to 60
minutes.
• After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
• The battery can be stored or directly installed
on the machine.
Lithium-Ion cells can be stored for a long
period without losing much of their
charge. When the machine is not being
used over a longer period of time it is best
to store the battery in charged condition.
Quick-Release Chuck
Use only 1/4" (6.35 mm) hex impact
accessories. Non-impact accessories
may break and cause a hazardous
condition. Inspect accessory prior to use
to ensure that it contains no cracks.
Place the direction switch (10) in the lock-off
(centre) position or remove battery pack before
changing accessories. To install an accessory,
fully insert the accessory. The accessory is locked
into place. To remove an accessory, pull the chuck
collar (8) away from the front of the tool. Remove
the accessory.
Adjusting the direction of rotation
Fig. A
• Set the direction switch (10) to position "" in
order to drive screws or to use it for drilling.
• Set the direction switch (10) to position "" in
order to remove screws
Switching the machine on and off
Fig. A
The on/off switch (11) is used for activating the
machine and adjusting rotation speed.
• Pressing the on/off switch (11) will activate
the machine, the further the switch is being
pushed, the faster the drill will turn. • Releasing the on/off switch (11) will stop the
machine.
• Move the direction reversing switch (10) to the
middle position to lock the movement of the on/
off switch. It cannot be activated in this position.
Only lay down the machine when it has
stopped running completely. Do not
place it on a dusty surface as particles of
dust could get into the mechanism.
Work light (9)
Fig. A
The machine is equipped with a work light to
illuminate the work location.
• It automatically switches on when the on/off
switch is being pressed.
• It automatically switches off when the on/off
switch is released again.
Belt hook (12)
Fig. A
The machine is equipped with a belt hook for
hanging the machine to your belt during use.
Always switch the direction switch (10) to
middle position to avoid accidental
startup of the machine.
7