Troubleshooting - Astone i-NAP Manual Del Usuario

D. The unit has been dropped or the enclosure damaged.
E. The unit exhibits a marked change in performance or does not operate normally.
12. Antenna - Do not connect an external antenna to the unit (other than that provided).
13.
Periods of Nonuse - If the unit is to be left unused for an extended period of time, such as a
month or longer, the power cable should be unplugged from the unit to prevent damage or
corrosion.
14. Servicing - The user should not attempt to service the unit beyond those methods
described in the user's operating instructions. Service methods not covered in the operating
instructions should be referred to qualified service person
ESD Remark (II):
In case of malfunction due to electrostatic discharge just reset the product (reconnect of
power source may be required) to resume normal operation.

TROUBLESHOOTING

Symptom Possible Problem
Unit does not AC adaptor isn't plugged
turn on into a working wall
socket or not plugged
into the power supply
jack on back of the unit
Unit doesn't The unit requires a reset
respond
11
Solution
Plug the AC adaptor into wall socket and
plug the connector into the supply jack on
the unit.
If unit is plugged in and doesn't respond, try
resetting the unit by following these steps:
a) unplug unit from power source
b) remove back up batteries
c) wait 1 hour, then resume use
Symptom Possible Problem
iPod didn't iPod is not installed properly
charge up iPod is locked up / frozen
iPod battery has problem
iPod does not Your iPod software is too old
respond to the
unit / iPod is iPod is not installed properly
Playing but no iPod is locked up / plays but
sound comes no sound comes out
out
Unit / iPod The unit is reacting to
performance is external interference
erratic
No sound from Volume is set too low
the unit
Unit / adaptor This is normal
gets warm after
Solution
Check for obstruction on your iPod.
Please refer to your iPod manual for details.
Upgrade software on you iPod. For details
visit
http://apple.com/ipod/download
Check for obstruction on your iPod.
Check the volume setting. Please refer to
you iPod manual for details. See above for
software upgrade information. You may
need to reset you iPod. To do so:
1. Toggle the Hold switch to hold position,
then off.
2. Press and hold the Menu and center
Select buttons at the same time until
Apple logo appears. You may need to
repeat this step.
Move unit away from potential sources of
external interference such as computers,
modems, wireless devices(routers) or
fluorescent light.
Make sure volume is turned up.
Turn unit off for awhile or lower volume.
12