Water Drainage - Woods AD Serie Manual Del Usuario

4.Water drainage

The water bucket (FIG A)
When the water reservoir is full, the
dehumidifier is shut off automatically
and the indicator light is lit.
Once the water reservoir is emptied
the unit will automatically restart.
1. Disconnect the dehumidifier from
the power source.
2. Remove the water bucket and
empty it.
3. Put the empty water bucket back
and check that the float moves
freely.
4. Connect the dehumidifier to the
power source.
Connecting a water hose (FIG B)
Remove the plug on the back of
the unit. Attach a water hose to the
pipe, lead the other end to a drain.
The hose diameter is 12 mm (inner
diameter). Make sure that the water
is drained downwards
5. Active ION HEPA filter
The Swedish-made, patented Active
ION HEPA filter ensures top-quality
filtration, without blocking the airflow.
This means that noise levels and
energy consumption are kept as low
as possible.
The Active ION HEPA filters need
to be replaced regularly to maintain
their high capacity, and to prevent
damages to the unit. The unit also
has a reminder alarm when you need to replace the filter.
Filter replacement (FIG C & D):
1. Remove the filter cover on the back
of the unit.
2. Remove and dispose of the expired
Active ION HEPA filter.
3. Insert a new Active ION HEPA filter.
4. Remove any dust or dirt on the fil-
ter cover and put it back. The filter
cover can be cleaned with warm
water and a mild detergent, or with
a vacuum cleaner.
English
Filter replacement reminder
After 970 hours of use, the unit
controls the status of the Active ION
HEPA filter. When controlling, all
buttons are locked and the air quality
light is flashing. The unit will repe-
at this test 4 times, with 10 hours
intervals If the filter is too dirty, the
replacement indicator is flashing.
Replace the filter and press and
hold the restet button for 5 seconds
to deactivate the alarm. If the filter
doesn't need to be replaced, the unit
will remind you to replace the filter
after 1500 hours of use.
The filter must be replaced
regularly, otherwise, the unit
might lose capacity and even
be seriously damaged.
6. Maintenance
• Clean the unit with a soft moist
cloth. Do not use solvents or strong
cleaners as this might damage the
surface of the unit.
• The cooling coils are best cleaned
with a rag and warm water.
7. Service
If the unit requires service, you must
first contact your local retailer. Proof
of purchase is required for all warran-
ty claims.
8. Warranties
2 years consumer warranty against
production faults. Please note that
the warranty is only valid upon the
production of the receipt. The warran-
ty is only valid if the product is used
in accordance with the instructions
and security warnings expressed
in this manual. The warranty does
not cover any damages caused by
improper handling of the product.
NOTE: The 2 years warranty only
applies to consumers and not for
commercial use of the unit.
This machine complies with EEC
directives 76/889 + 82/499
14
NOTE! Get a 6-years warranty!
Register at warranty-woods.
com and replace the Active ION
HEPA filter at least once a year.
Please visit woods.se for more
information.
9. Hints
• Sometimes it may be useful to use
a frost guard or heater fan to make
sure that the temperature does
not fall below +10˚C. Even if the
AD-series can dehumidify down
to temperatures as low as +5°C,
their capacity will increase at higher
temperatures as warm air carries
more water.
• For maximum capacity in a room, it
is recommended that the air supply
from outside and from adjoining
rooms is minimized – close doors
and ventilators.
• Expect higher dehumidification
capacity during Autumn / Summer
because the outside air is warmer
and more humid.
• To achieve safe and reliable pro-
tection against mould and moisture
damage, keep the relative humidity
between 50% and 60%.
• Use a higher fan speed for quicker
dehumidification and air cleaning.